Subject: | |
From: | |
Reply To: | |
Date: | Tue, 15 Sep 1998 15:48:24 GMT |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
CHRS: IBMPC 2
CODEPAGE: 437
MSGID: 240:244/116 45eec59b
REPLY: 240:44/0 70445533
PID: FDAPX/w 1.12a UnReg(424)
Hi Bob,
I wire all my frames, deep brood frames I divide into four equal spaces and
punch holes throught the side bar centres, the punch sets a brassed eyelet into
teh wood. I pull a stainless steel wire through the eyelets and tye it off
around a gimp pin set into teh edge of the frame side, I then proceed to strain
the wire using small pliers at each eyelet until I reach the reel end of the
wire where I tye it off around another gimp pin. (about five revolutions not a
knot) I knock the gimps pins in with a hammer. I then crimp the wire with a
pair of rotating cogs.Next I set the foundation into the frame and pass a 50 or
25 volt ac current through the wire momentarily, yes the wire expands but
contracts almost immediately becoming once again tensioned, the timing is a
skill you will soon learn, if you dont you will have three pieces of wax laying
on the floor each time you electrify the wire. I bought all the bits, punch,
eyelets, wire and crimper in Germany for about twenty quid some time back. a
twelve volt dc charger will do as will a car battery. Best of luck.
[log in to unmask]
from the garden of England (Kent)
---
* Origin: Kent Beekeeper Beenet Point (240:244/116)
|
|
|