>In a message dated 96-12-23 19:37:04 EST, [log in to unmask] (Vince
>Coppola)
>says:
>
> << I have used rough cut to make supers, bottom boards ect. and
> recommend planning on one side. This will give you material of unuform
> thickness and make it much easier to produce parts that fit. Leave the
> rough side in and it will be easier to paint the outside (smooth). >>
>
Actually, I'd prefer the rough side OUT. That way the bees won't go
coating up the interior with propolis, as they would if the rough surface
faced in.
I have never painted the inside of hives, but see the point as emphasized
in the last post.
If I could, I would opt for the dipping treatment, which at least one guy
in our area was (is?) using. The hive parts were dipped in a molten
mixture of paraffin and rosin, and from what I was told, the super boxes,
lids, etc. really sizzle and soak that stuff up. Then over time, it
weathers nicely to a natural greyish tone which is pretty good camoflage.
After spending so much time, effort, and money on building good equipment,
it only seems fitting to give it a good overall treatment like this.
Anyone on Bee-L been using the dip?
I have settled on a latex deck enamel or, preferably, Cuprinol stain. The
stain is an excellent treatment, but floors are best soaked in it for a
while. It still isn't as good as the hot dip.
|