> We have to be very careful when we turn it on
> under conditions when the pipes have gotten
> cold (and now they are off the floor). We just
> give it a few seconds on and then stop.
> Then a few more...... Until the honey is
> moving and warm in the pipes.
That pump is trying to pull a near solid!
Not good for the seals!
Why not put some heating tape on the pipe, bypass the little built-in
thermostat, and heat the pipe and its contents before turning on the pump?
***********************************************
The BEE-L mailing list is powered by L-Soft's renowned
LISTSERV(R) list management software. For more information, go to:
http://www.lsoft.com/LISTSERV-powered.html