Subject: | |
From: | |
Reply To: | |
Date: | Tue, 27 Jun 2006 18:52:25 +0100 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Please,
where can I get a design for a good wiring/embedding board suitable
for MD deeps ?
I know there is a design out there that uses a cam to bend the side
bars. When these spring back out they tension the wires. But does it
really work ? Surely a lot of tension must be lost in the outer most
wires due to friction ?
Is it better to pass current through one wire at a time, or all in
parallel ?
Is it better to have the tensioned wires resting on the wax, so they
"fall" into it once hot ? Or is it better to have the wax resting on
top of the wires ?
Surely there are small differences in the geometry of side bars, so I
need some method of adjusting (up or down) the plane in which the wires
lie ? No ?
In the past I kept the wires taught by pulling them tight with a frame
nail, but it is not very convenient.
I don't want to re-invent the wheel ....... again ....... :-)
Thanks
-- Visit www.honeybeeworld.com/bee-l for rules, FAQ and other info ---
|
|
|