Hi all
A simple way to make a 'D' shaped hand grip...
Working from the side of a table saw so that the blade has it's flat surface
facing you.
Place two wooden 'fences' at the width of the board and a front stop that
registers the part with the top edge of the 'D'.
Two wooden ramps are set inside the fences so that as the board is pushed
away from the operator, the blade penetration decreases to nothing.
Watch out for the exposed saw blade!
Best Regards & 73s... Dave Cushman G8MZY
Beekeeping and Bee Breeding Website
http://website.lineone.net/~dave.cushman
Best Regards & 73s... Dave Cushman G8MZY
Beekeeping and Bee Breeding Website
http://website.lineone.net/~dave.cushman
::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::
-- Visit www.honeybeeworld.com/BEE-L for rules, FAQ and other info ---
::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::