Sender: |
|
Date: |
Sat, 9 Oct 2004 10:58:15 -0500 |
Reply-To: |
|
Subject: |
|
MIME-Version: |
1.0 |
Content-Transfer-Encoding: |
7bit |
Content-Type: |
text/plain; format=flowed; charset="iso-8859-1";
reply-type=original |
From: |
|
Comments: |
|
Parts/Attachments: |
|
|
On the Ameda pump pressure gauge you read the inside numbers not the outside
numbers. This gauge has a circle and two numbers, one above and one below
the circle. You stick the gauge in the flange and turn on the pump and get a
reading. The one below reads in milibars of mercury, I think, and is the
correct number to read when testing pumps. Kind of confusing but there must
be a need for the outer numbers (I don't know what it would be). Also, you
may need to either test one side only, or have the other side plugged off. I
use two gauges myself, one in each side, but Ameda also has a plug you can
get for one side and the gauge for the other.
Kathy Eng, BSW, IBCLC
***********************************************
To temporarily stop your subscription: set lactnet nomail
To start it again: set lactnet mail (or digest)
To unsubscribe: unsubscribe lactnet
All commands go to [log in to unmask]
The LACTNET mailing list is powered by L-Soft's renowned
LISTSERV(R) list management software together with L-Soft's LSMTP(R)
mailer for lightning fast mail delivery. For more information, go to:
http://www.lsoft.com/LISTSERV-powered.html
|
|
|