Subject: | |
From: | |
Reply To: | |
Date: | Sat, 12 Oct 2013 21:11:30 -0400 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
I used to have a model that worked well but can't use it any more because of policies against latex----I took a small balloon, filled it with water and tied it off. I then took a #25 needle and made four or five holes in the end away from the tied off part. As long as I kept the holes facing upright it didn't leak. A bit of pressure in the appropriate place and voila!
On 2013-10-12, at 3:58 PM, Nancy E. Wight MD, IBCLC, FABM, FAAP wrote:
> There is already a model - made in Germany and approximately $1,000. Don't
> remember the ordering info.
>
> Nancy
> Nancy E. Wight MD, IBCLC, FABM, FAAP
> Neonatologist, San Diego Neonatology, Inc.
> Medical Director, Sharp HealthCare Lactation Services
> Sharp Mary Birch Hospital for Women and Newborns
>
> ***********************************************
>
> Archives: http://community.lsoft.com/archives/LACTNET.html
> To reach list owners: [log in to unmask]
> Mail all list management commands to: [log in to unmask]
> COMMANDS:
> 1. To temporarily stop your subscription write in the body of an email: set lactnet nomail
> 2. To start it again: set lactnet mail
> 3. To unsubscribe: unsubscribe lactnet
> 4. To get a comprehensive list of rules and directions: get lactnet welcome
***********************************************
Archives: http://community.lsoft.com/archives/LACTNET.html
To reach list owners: [log in to unmask]
Mail all list management commands to: [log in to unmask]
COMMANDS:
1. To temporarily stop your subscription write in the body of an email: set lactnet nomail
2. To start it again: set lactnet mail
3. To unsubscribe: unsubscribe lactnet
4. To get a comprehensive list of rules and directions: get lactnet welcome
|
|
|