I used to have a model that worked well but can't use it any more because of policies against latex----I took a small balloon, filled it with water and tied it off. I then took a #25 needle and made four or five holes in the end away from the tied off part. As long as I kept the holes facing upright it didn't leak. A bit of pressure in the appropriate place and voila! On 2013-10-12, at 3:58 PM, Nancy E. Wight MD, IBCLC, FABM, FAAP wrote: > There is already a model - made in Germany and approximately $1,000. Don't > remember the ordering info. > > Nancy > Nancy E. Wight MD, IBCLC, FABM, FAAP > Neonatologist, San Diego Neonatology, Inc. > Medical Director, Sharp HealthCare Lactation Services > Sharp Mary Birch Hospital for Women and Newborns > > *********************************************** > > Archives: http://community.lsoft.com/archives/LACTNET.html > To reach list owners: [log in to unmask] > Mail all list management commands to: [log in to unmask] > COMMANDS: > 1. To temporarily stop your subscription write in the body of an email: set lactnet nomail > 2. To start it again: set lactnet mail > 3. To unsubscribe: unsubscribe lactnet > 4. To get a comprehensive list of rules and directions: get lactnet welcome *********************************************** Archives: http://community.lsoft.com/archives/LACTNET.html To reach list owners: [log in to unmask] Mail all list management commands to: [log in to unmask] COMMANDS: 1. To temporarily stop your subscription write in the body of an email: set lactnet nomail 2. To start it again: set lactnet mail 3. To unsubscribe: unsubscribe lactnet 4. To get a comprehensive list of rules and directions: get lactnet welcome