Some one asked about a router bit for cutting hand holds. Just for a change, try using an angle grinder. I have a small angle grinder and a special disk for carving timber. The disk is made of steel and has teeth around the edge shaped very much like the teeth on a chain saw. This arrangement is very useful for grinding/shaving away bits of waste timber that you can not get at with ordinary tools. The promotional material that comes with the disc shows that a good operator can cave some very decorative pieces with this device. You could use it to make some very nice hand holds. I cannot give any practical hints because I have not needed to make/get any new boxes since I bought the disc. WARNING If you don't handle them properly, chain saws and angle grinders have a nasty habit of kicking back at you. I have also used cleats with telescopic lids. The trick is to place the cleat lower down so that it does not interfere with the telescopic lid. I prefer to use cleats made for 50mm * 25mm timber and place it at about the same level where the hand holds are normally cut. That gives me a comfortable grip with fingers under the cleat and thumb over the top of the box. Regards Chris Allen