Many thanks for the replies. Here are my experiences: 1. Raw linseed oil : several individuals prepared their surfaces using this technique. Where the concrete was relatively porous, the oil was rapidly absorbed. Several coats were required. Sooty molds were a problem afterwards. 2. Epoxy resin: A prejudice against because of probable poor installation of surface. In establishments such as hardware stores, local to home, such surfaces are seen. When individuals bring in the snow from outside and it melts - the result is a real potential for broken legs, heads etc. Once you start moving, there is no stopping until you hit something. In France, a honey house that was built to demonstrate honey extraction also had an epoxy floor - but with a granular ingredient added to add grip. That it achieved, but the wax, propolis and honey were a pain to remove from the surface. Also, the gritty material was badly distributed and it resulted in a patchy finished item. 3. Concrete Paint: Blown off during pressure washer cleaning, resulting in a potential for honey contamination. As suggested, I shall get in contact with the relevant authorities to hear what advice they give. Then when all is in place -I shall pass on my thoughts. Trevor, your floor level cooing strips. Fine for removing the tight corner problem at floor level - but how is the junction between the coving and the floor / wall achieved. Do you use a "shower" type mastic (acrylic)? Peter Rather chilly at -22° C, snowing, with a breeze of 25 kph. :::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::: -- Visit www.honeybeeworld.com/BEE-L for rules, FAQ and other info --- ::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::