ISEN-ASTC-L is a service of the Association of Science-Technology Centers
Incorporated, a worldwide network of science museums and related institutions.
*****************************************************************************

I particularly agree with the moisture comment.  We have done a demo
with rice krispies exploding all over the place once the charge has
been built up (it makes our curators crazy!), and it ONLY works
correctly if the cereal has been dried out for several days prior to
the demo.
Beryl

>ISEN-ASTC-L is a service of the Association of Science-Technology Centers
>Incorporated, a worldwide network of science museums and related institutions.
>*****************************************************************************
>
>Unpredictability is part of the nature of Van de Graff's.
>
>It doesn't take much for them to stop working or to
>perform really poorly.  Two things are particularly bad
>for building a charge... any moisture in the air and the
>charge will bleed off into the air very quickly... and any
>tarnish or dirt on the ball and it won't hold a charge.
>
>Depending on what your ball is made of (probably
>spun aluminum) you could try cleaning it with an
>alcohol pad (inside and out) before you run it.  Clean
>the belt too...
>
>Good luck...
>
>Dave Taylor
>------------------------------
>
>>  From: Jesse Alexander <[log in to unmask]>
>>  Reply-To: Informal Science Education Network
>>  Date: Sat, 14 Feb 2004 02:56:24 -0800
>>  To: [log in to unmask]
>>  Subject: VDG Questions
>
>>  Hey Folks,
>>
>>  I'm looking for inexpensive ("pre-owned" is ok) Van de
>>  Graaff generators that can be easily taken on the road
>>  during traveling science programs. I am also looking
>>  for "care and feeding" guides for VDGs.
>>
>>  The generator should be about 24" tall so that it can
>>  be easily seen during assemblies of 300+ kids.
>>
>>  We have had a lot of problems with "unpredictable" VDG
>>  behavior on the road. Something seems to be shorting
>>  out the globe. I can develop a charge by holding my
>>  fingers about a 1/4" from the belt, but the charge
>>  somehow doesn't make it to the globe (once I remove my
>>  fingers-of course). The rubber belt is exposed on our
>>  Pasco SF-9722 VDG.
>>
>>  Any ideas?
>>  Jesse Alexander, WB2IFS
>>  Science Evangalist/Demonstrator
>>  Liberty Science Center
>
>***********************************************************************
>More information about the Informal Science Education Network and the
>Association of Science-Technology Centers may be found at http://www.astc.org.
>To remove your e-mail address from the ISEN-ASTC-L list, send the
>message  SIGNOFF ISEN-ASTC-L in the BODY of a message to
>[log in to unmask]


--
Beryl Rosenthal, Ph.D.
Director of Exhibitions and Public Programs
MIT Museum
265 Massachusetts Ave.
Cambridge, MA  02139
Tel: 617-452-2111
Fax: 617-253-8994
[log in to unmask]

***********************************************************************
More information about the Informal Science Education Network and the
Association of Science-Technology Centers may be found at http://www.astc.org.
To remove your e-mail address from the ISEN-ASTC-L list, send the
message  SIGNOFF ISEN-ASTC-L in the BODY of a message to
[log in to unmask]