Frank & Phronsie Humphrey wrote:
>
> I am at present removing several colonies from buildings by trapping with
> screen cone method. Every time I do this, it is always a hassle to get the
> cone just right and then sealing around it. Today I tried something new.
> I purchased several sizes of clear plastic tubing. I reduced the opening
> to one small entrance of about 1 1/2 " X 3/4". I then placed a 3" section
> of 3/4" tubing and sealed it in place with "Great Stuff" foam sealer. I
> then sealed up all remaining openings that the bees found. I then put a
> short section of 5/8" tubing in the 3/4" and 3/8" into the 5/8". The 3/8"
> tubing is about 8" long and the other end was placed just inside the
> entrance of a NUC in front of the original entrance. For about 30 minutes
> the bees were frantic to get back in but couldn't find an entrance to their
> old nest. Finally a few found the NUC and started scenting. After 45
> minutes, most bees were entering the new hive with returning field bees
> searching for a short time and then they too entered.
>
> It took about 30 minutes for the bees to start exiting via the tubing.
> However once started they came out in a steady stream. If this continues
> to work as well as it started, I will never again use screening.
>
> Frank Humphrey
> [log in to unmask]
This sounds promising but what about those good time summer party boys -
drones plugging up the tubing?
plugging up the tubing.