Subject: | |
From: | |
Reply To: | |
Date: | Sun, 21 Jul 2019 12:45:01 -0400 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
There were 3 very good responses to Rebekah Lee's query, all of which
included the entirety of Rebekah's original post
When [log in to unmask] quoted the entirety of Rebekah's original
post, his reply read:
" some 1/2 frames not capped".
Some options.....
Take out and extract the sealed frames, put the unsealed frames together
into super(s) and let the bees finish them off (seems best to me). If not
too many unsealed frames, extract the lot and average will still be lower
than 20% water.Leave all frames on a bit longer...seems like they are close
to finishing and capping the unsealed ones.
When [log in to unmask] quoted the entirety of Rebekah's original post, his
reply read:
I'd wait until moisture is at most 19%. 18.5% is better. Letting
extracted honey sit will not usually reduce moisture content.
When [log in to unmask] quoted the entirety of Rebekah's original
post, his reply read:
Considering cool and wet weather in the past weeks, it will take longer for
the bees to reduce moisture in the hive. 20% moisture levels in uncapped
honey is on the high side. Leave the uncapped frames in the hive for now,
next week’s heat wave will probably give the bees a chance to cap the cells
properly. 15%-18% moisture level is acceptable.
Good replies, excessive quotes.
***********************************************
The BEE-L mailing list is powered by L-Soft's renowned
LISTSERV(R) list management software. For more information, go to:
http://www.lsoft.com/LISTSERV-powered.html
|
|
|