Hi Chris > http://www.dave-cushman.net/bee/roger_punch_frame.html > I don't know of a source of 9.5mm brass tube. Will .38 special do? I thought about this while assembling the page... .38 special is a bit short, but .357 Mag would be about right, use a Dremel tool to cut the head off... http://www.dave-cushman.net/bee/dremel.html The thin walled tube that results can then be sharpened on one end using a de-burring tool... http://www.dave-cushman.net/bee/deburringtool.html or alternatively, sharpen using a carrot cutter... http://www.dave-cushman.net/bee/bradrad.html#cone Regards & Best 73s, Dave Cushman, G8MZY http://website.lineone.net/~dave.cushman or http://www.dave-cushman.net Short FallBack M/c, Build 6.02/3.1 (stable) *********************************************************************************** * Full guidelines for BEE-L posting are at: * * http://www.honeybeeworld.com/bee-l/guidelines.htm * ***********************************************************************************