Print

Print


eileen shea <[log in to unmask]> wrote:

> I used to have a model that worked well but can't use it any more because
> of policies against latex----I took a small balloon, filled it with
> water and tied it off.  I then took a #25 needle and made four or five
> holes in the end away from the tied off part.  As long as I kept the
> holes facing upright it didn't leak.  A bit of pressure in the
> appropriate place and voila!

Have you tried this using a non-latex condom instead? The bonus being
that there is a nipple-shaped protrusion on the end also.

Lara Hopkins

             ***********************************************

Archives: http://community.lsoft.com/archives/LACTNET.html
To reach list owners: [log in to unmask]
Mail all list management commands to: [log in to unmask]
COMMANDS:
1. To temporarily stop your subscription write in the body of an email: set lactnet nomail
2. To start it again: set lactnet mail
3. To unsubscribe: unsubscribe lactnet
4. To get a comprehensive list of rules and directions: get lactnet welcome