eileen shea <[log in to unmask]> wrote: > I used to have a model that worked well but can't use it any more because > of policies against latex----I took a small balloon, filled it with > water and tied it off. I then took a #25 needle and made four or five > holes in the end away from the tied off part. As long as I kept the > holes facing upright it didn't leak. A bit of pressure in the > appropriate place and voila! Have you tried this using a non-latex condom instead? The bonus being that there is a nipple-shaped protrusion on the end also. Lara Hopkins *********************************************** Archives: http://community.lsoft.com/archives/LACTNET.html To reach list owners: [log in to unmask] Mail all list management commands to: [log in to unmask] COMMANDS: 1. To temporarily stop your subscription write in the body of an email: set lactnet nomail 2. To start it again: set lactnet mail 3. To unsubscribe: unsubscribe lactnet 4. To get a comprehensive list of rules and directions: get lactnet welcome