> fsr's (force sensing resistors) are good for this purpose, Save yourself the trouble. Been there, done that, still have the emotional scars. :) Wanna buy the very expensive "evaluation kit" of Tekscan Flexiforce FSRs for which I paid about $100? No, I won't take your money, I am not a thief or a con artist. They had the best specs of the bunch, and while I bought several of these sample kits, the bottom line is that these things are only good for the most general impression that "force has been applied" or "more force than before" or "less force than before. If you look carefully at their detailed specs, which they grudgingly provide when you ask pointed questions about applications where the sensor acts as anything more than a switch, and they spout nonsense like: "DRIFT: < 3% / logarithmic time (Constant load - 25 lb)" Don't feel bad if you do not understand this spec at all. Neither did I. The concept of "the log of time" is a highly entertaining idea, one we would like to see published in the journals for discussion. :) What they are covering up here is that these things are utterly useless when under any load at all for any time at all. The resistance of the sensor drops faster than the price of honey at a diabetic convention, and slowly reaches some sort of minimal measurement, but never really stops decreasing, even after months. If you think about a log curve, you can imagine how rapid the degradation of the sensor is under a constant load, and just how fast the reading "drops off". There's another spec that is a real knee-slapper, and would be crucial to the design of Wheatstone bridge to slide into the circuit "across from" the Flexiforce sensor as a temperature compensating strategy. The spec says: "0.36% per degree C" Which equates to a "3600 TCR PPM/Deg C". Now compare this with known standard values for commonly-used resistor materials, and you will find: TCR PPM/ Deg C Material -------------- ------------------------ 3600 Flexiforce Sensor 3700 Gold 3800 Aluminum 4000 Copper 660 Palladium Silver Ink (Dupont 6134) 3350 Pure Silver Ink (Dupont 6160) How could the sensor have a "better" TCR than gold? What might one use in a Wheatstone bridge with this sensor? The specs are absolute and utter garbage, just like the FSR sensors as an entire product category if you had any idea of using them for any sort of quantitative measurement. Yes, they can be used to make qualitative comparisons, but not anything one could dignify with the term "measurement". ****************************************************** * Full guidelines for BEE-L posting are at: * * http://www.honeybeeworld.com/bee-l/guidelines.htm * ******************************************************