I like this protocol, but would like to add that it works better if all parts are rinsed with cold water right after use and only then washed in hot soapy water. Using hot water right away will make the proteins to coagulate and stick to the material.
For home environment I would use normal dishwashing detergent in the same amount as used for doing the dishes.
Warmly,
Gonneke, IBCLC, LLLL in southern Netherlands
Kathy Eng <[log in to unmask]> wrote: Brenda, some hospitals here say use Ivory dishwashing soap but I do not
know of any research that says this.
I find that may soaps are highly perfumed, too highly perfumed. Moms may
also be using too much soap or layering it on.
Here is what mothers have taught me that works very well. Immediately
after pumping, pour milk into container and put in freezer or
refrigerate as per hospital instructions. Then use a big bowl, or
similar small plastic bucket or container, and fill with (fresh) hot
soapy water. Put pump parts into the hot soapy water. Let soak for a few
minutes. Rinse twice with clean water, shake out excess water and dry on
paper towel or clean cloth. I like a bowl big enough that all parts fall
into the water not stick up above the water line.
If mom hand washes the parts with a lot of soap (meaning soaps up her
fingers or the brush and thickly soaps the plastic pieces this way), she
may use too much soap and it may not rinse well. If mom lets her pieces
sit out and the milk hardens, briefly soaking in a bowl of hot water
will not clean it well enough.
Those pink square "buckets" that come with the water container and cup
are perfect for washing pump parts. Perfect size and perfect fit for the
kitchen sink.
What I see is moms using a ton of soap -- if a little is good, a lot is
better. I use just what I would for dishes, which is enough to make a
lather and not a thick coating. Pump pieces are really very easy to
clean if you do it immediately after pumping.
I work with WIC moms and they often have very little money to buy
sterilizer bags or special soaps. We use what they have. I use whatever
soap they have at the kitchen sink and I do not find the pieces smell of
perfume or look cloudy because I do not use a ton of soap. I wash parts
if mom needs help after I loan her a pump for her NICU baby or if we are
in the clinic and she is not going home immediately. So I have washed
literally hundreds of pump parts. If we don't have a big bowl, I use
only a couple of drops of soap to hand wash the pieces, and find they
come shiny clean and have no soap smell or residue.
I would try my suggestion of a few drops of soap in a big bowl of hot
water, with a double rinse, and see if you still have the same problem.
Kathy Eng, BSW, IBCLC
***********************************************
To temporarily stop your subscription: set lactnet nomail
To start it again: set lactnet mail (or digest)
To unsubscribe: unsubscribe lactnet
All commands go to [log in to unmask]
The LACTNET email list is powered by LISTSERV (R).
There is only one LISTSERV. To learn more, visit:
http://www.lsoft.com/LISTSERV-powered.html
Met vriendelijke groet,
Gonneke van Veldhuizen, IBCLC
lactatiekundige
* * * * * * *
www.eurolac.net
praktijk voor lactatiekunde
centrum voor borstvoeding informatie en educatie
* * * * * * *
www.eurolac.net/forum
forum NEDlact: http://anne.messageboard.nl/16435/
***********************************************
To temporarily stop your subscription: set lactnet nomail
To start it again: set lactnet mail (or digest)
To unsubscribe: unsubscribe lactnet
All commands go to [log in to unmask]
The LACTNET email list is powered by LISTSERV (R).
There is only one LISTSERV. To learn more, visit:
http://www.lsoft.com/LISTSERV-powered.html
|
